Infiltration blocks

Specifications

It happens more often that there rain floods occur. This is because more often paved surfaces (buildings, car parks, driveways, etc).

To solve this problem, there are now infiltration systems, which slowly infiltrating the rainwater into the ground.

It can also occur that there is no possibility to discharge the rainwater due to lack of a sewer or canal.

In these cases an infiltration is the right solution.

That is why we have these systems in our product range:

The infiltration blocks. They exist in different volumes, depending on the application.

The necessary volume depends on the total paved surface (roof, terrace, driveway, etc.), as well as the permeability of the soil.

They can be placed both in series and in parallel.
For installation in series you have a sleeve required per additional block, for mounting in a parallel Distributor.
 

Provide a ventilation on the last block.

To prevent blockage we recommend that install a filter in front of the infiltration blocks. These are separate available.

The blocks can have a maximum vertical load of 100 kn/m², and a horizontal of 20 kn/m².

The blocks are isnpectable and cleanable, depending on the installation.

They can be installed with the inlet and overflow at the top or the bottom. At the top will give a better and faster infiltration, but makes it more dificult to inspect and unpossible to clean. We recomand to install them at the bottom, and to bring the connecting tubes from the top to the bottom with elbows of 45°.

We recomand to install a control pit behind the block. This facilitates the inspection and cleaning.

They are equipped with an inlet and overflow of 160 mm. On demand available in 110 and 125 mm.